Dongguan Zhongbang Jelly Co., Ltd. to share the selection of Hot Melt Glue gun coup, Zhongbang animal glue Summary:
First, when using the hot melt glue gun, before the hot melt glue gun is plugged in, please check whether the power cord is intact and whether the bracket is ready; whether the used glue gun has inverted glue or not. The glue gun should be warmed up for three to five minutes before use. The glue gun should stand upright on the table when not in use. Please keep the surface of the hot melt strip clean to prevent impurities from blocking the nozzle.
If no glue is found during the use of the glue gun, please check whether the glue gun is hot. If the glue gun cannot heat normally, the reasons may be as follows: 1. The glue gun power is not plugged in; 2. The glue gun is short-circuited And burn out.
Under normal heating conditions of the glue gun, the reason may be as follows: 1. The gun mouth is blocked by impurities and should be handled by a professional; Second, the glue gun is poured to make the rubber strip thicker, and only the rubber strip is needed at this time. Gently rotate it a week and carefully pull back a small part, peel off the thickened part of the strip and continue to use it. When the glue stick in the glue gun is not used up, try not to pull the glue stick out of the glue gun. If there is a backflow phenomenon in the glue stick in the glue gun, stop using the glue gun immediately, and other professionals can use it only after cleaning the reversed hot melt glue. The glue gun is heated continuously for more than fifteen minutes. Please disconnect the power supply.
