Bookbinding hot melt adhesive

【China Aluminum Industry Network】 daily material glue can not avoid the use of Hot Melt Glue gun. Let's take a look at the situation in the construction of hot melt glue guns that cannot be used in the renovation. How to deal with them? How to use hot melt glue guns?

If the glue gun can't get out of glue normally during use, please check if the glue gun has heat. If the glue gun does not heat properly, the reason may be:

1, glue gun power is not energized;

2, glue gun heater has been burned;

3, such as glue gun fever is normal, the reason may be: due to impurities in the gun mouth blocked, should be handled by a professional.

PS: Other considerations

• Keep the surface of the hot melt strip clean and prevent impurities from blocking the nozzle.

When the glue stick in the glue gun is not used up, please do not pull the glue stick out of the glue gun as much as possible. Otherwise, the glue may be poured, which will affect the glue speed.

When the backflow phenomenon occurs in the glue stick in the glue gun, immediately disconnect the power supply and stop using it. It can be used only after being repaired by a professional.

• If the applicator does not use for more than 15 minutes of continuous heating, disconnect the power and increase the service life of the applicator

• Avoid using a hot melt gun in a humid environment and it may cause electric shock. Non-professionals must not dismantle the hot melt glue gun.

How to use hot melt glue gun?

Before using the hot-melt glue gun, please check whether the power is on, whether the bracket is ready, and whether the used glue gun is smooth;

• When using the hot melt glue gun, insert the power cord and warm it up for about 5 minutes or until the tape is completely melted. When the glue gun is not in use, stand upright on the desktop.

After the melted glue sticks, place the glue gun nozzle at the point where it needs to be glued. Press the trigger lightly to let the glue flow out naturally.

After using the nozzle down, unplug the power plug;

Do not pull the tape from the glue inlet;

• Since the temperature of the hot melt applicator is extremely high during use, do not touch the gun mouth or the gel with your hands.