- Suitable for lighting, cup industry, toys and other industries
Julong Chemical Co., Ltd. is committed to the development and exploration of glue and paint technology, and has accumulated rich experience in the field of glue. Longlong glue has the characteristics of simple use and good effect, plus the production management specification and technical support, and has been widely accepted. The user's pro-gaze. In addition, Julong Company has obvious technical advantages in the use of plastics in lighting. JL-350 series glues specially developed and produced are widely used in lighting, insulation cups, toys, sports equipment and other industries in the Pearl River Delta. The market and Zhejiang market are very popular.
Julong lighting special glue JL-350 is a glue specially developed for an internationally renowned lighting company in Jiangmen. On the basis of good adhesion, it meets the environmental protection requirements of exporting foreign countries, especially Europe and the United States, in particular:
1. Wide range of applications, suitable for PP, PC, ABS, PS, nylon, metal (aluminum, electroplating materials, tinplate, etc.) materials stick to each other.
2, the liquid color is transparent, no bubbles after drying, the product is perfect, PC material is not easy to burst after bonding.
3, single-component solvent, easy to use.
4, the drying time is short, can be positioned in 1-2 minutes, 1 hour dry, 8 hours test.
5 Good bonding effect, long aging resistance, and meet the need of long-term firm bonding.
6. The cured product after bonding has good flexibility, is not easy to peel off, and has good cushioning properties.
7. The addition of antioxidants and other ingredients can effectively prevent the yellowing of the cured product.
8, liquid odor, RoHS compliance, environmental protection and health.
Agglomeration JL-350 glue performance parameters and process flow:
The above data is measured in the laboratory for reference only; products are subject to change without notice!
Process flow:
First, the surface clean
The adhesive surface is greased and the moisture is cleanly treated (Note: The surface must be thoroughly cleaned so as not to affect the product adhesive effect).
Second, glue
Apply the glue on the two adhesive surfaces after cleaning, and let them dry at room temperature until the surface is dry (the surface is not sticky); then press the two adhesive surfaces together
Note: 1, glue must be uniform, so as not to affect the consistent drying, glue can not be too thick, affecting the drying speed.
2, if it is a single-sided glue, adhesive must be immediately glued, so as not to affect the adhesive effect.
Third, drying
Put the product under normal temperature (25°C); fake (initial) drying time is 1 hour, and drying time is 8-12 hours (different temperature drying rate is different, can be 40-50°C baking /3- 4H can).
